Abstract
ABSTRACT Sn–Sb solder alloys (2; 5.5 and 10wt-% Sb) were directionally solidified with a view to permitting the effect of a wide range of solidification cooling rates to be related to the resulting microstructure, which is shown to be formed by a cellular Sn-rich matrix with Sn–Sb intermetallic particles (IMCs) randomly distributed in the matrix The corrosion resistance of these alloys is investigated by electrochemical impedance spectroscopy (EIS), equivalent circuit and linear polarisation and the results correlated with microstructural features. The increase in the alloy Sb content is shown to change the nature/morphology of the Sn–Sb IMCs, consequently affecting the corrosion resistance. The EIS data indicated that the Sn–10wt-%Sb alloy has the best corrosion resistance because of the high resistance of its oxide barrier layer. The polarisation curves also indicate lowest corrosion rate and nobler potential related to the Sn–10wt-%Sb alloy, which has also been confirmed by calculations of polarisation resistance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
