Electrochemical and Tension Tests Behavior of API 5L X60 Pipeline Steel in a Simulated Soil Solution

Abstract

In this work electrochemical impedance spectroscopy (EIS) and slow strain rate tests (SSRT) were used for the evaluation of API 5L X60 carbon steel in contact with a simulated soil solution called NS4. EIS monitoring before and after performing the tension tests was carried out. SSRT were carried out in NS4 solution at room temperature to simulate dilute ground water that has been found associated with stress corrosion cracking (SCC) of low carbon steel pipelines. A strain rate of 1x10-6sec-1was used. According to the analysis of SSRT, the X60 pipeline steel is highly resistant to SCC. In order to perform the electrochemical test, two working electrodes were considered, a complete specimen, before the SSRT and a fractured specimen after the SSRT. The analyses of results show that the electrochemical response was different in each samples. The corrosion rate (CR) obtained by the two corrosion techniques revealed that the CR of the fractured specimen was higher than the CR of the complete specimen. This behavior is attributed to the fact that the fractured specimen present a high degree of tortuosity and this condition activate the corrosion process. In addition, according to the cathodic Tafel slope, the reduction reacction was influenced by a difusion process. A combine fracture type in SSRT was observed: ductil and brittle with a transgranular appearance. Some pits and internal cracks close to the fracture zone were observed. The failure process and mechanism of X60 steel in NS4 solution are controlled by dissolution and hydrogen embrittlement.