Efficient degradation and deiodination of iopamidol by UV/sulfite process: Assessment of typical process parameters and transformation paths.

Abstract

Iopamidol (IPM) is widely used in medical clinical examination and treatment and has immeasurable harm to the ecological environment. The combination of UV and sulfite (UV/sulfite) process was developed to degrade IPM in this study. In contrast to that almost no removal of IPM was observed under sulfite reduction alone, the UV/sulfite process could efficiently reductively degrade IPM with the observed rate constant (kobs) of 2.08 min-1, which was nearly 4 times that of UV irradiation alone. The major active species in the UV/sulfite process were identified as hydrated electrons (eaq-) by employing active species scavengers. The influence of the initial pH, sulfite dosage, IPM concentration, UV intensity and common water matrix were evaluated. The degradation of IPM reached nearly 100% within only 2.5 min at pH 9, and kobs increased at higher initial sulfite dosages and greater UV intensities. HCO3- had a limited effect on the degradation of IPM, while humic acid (HA) was found to be a strong inhibitor in the UV/sulfite process. With the synergistic action of UV/sulfite, most of the iodine in IPM was found to release in the form of iodide ions (up to approximately 98%), and a few formed iodide-containing organic compounds, reducing significantly the toxicity of degradation products. Under direct UV irradiation and free radical reduction (mainly eaq-), 15 transformation intermediates of IPM were produced by amide hydrolysis, deiodination, hydroxyl radical addition and hydrogen abstraction reactions, in which free radical attack accounted for the main part. Consequently, the UV/sulfite process has a strong potential for IPM degradation in aquatic environments.