Efficient and low-drift point-cloud mapping method for GNSS weak and obstructed areas

Abstract

Abstract Road modelling based on point-cloud data often encounters signal-rejection areas, where the absence of absolute position constraints leads to rapid error accumulation in the constructed map. To mitigate error growth, the manual setting of control points is necessary, which compromises automation in the mapping process and causes a challenging trade-off between efficiency and accuracy. To address these issues, in the present study, we designed a fast and efficient map-construction method that provides absolute pose constraints for simultaneous localisation and mapping (SLAM) based on the bidirectional filter position of global navigation satellite system (GNSS)/inertial measurement unit (IMU) integrated navigation. First, we designed an absolute position constraint factor (BF_Factor) updated at each epoch according to the reference-position difference and time-delay error, which can significantly mitigate error divergence during mobile mapping in a GNSS-rejected region. An adaptive noise model was then constructed for the above factors so that the weights of different factors could be adjusted automatically to achieve a more accurate mapping result. Finally, we conducted experimental tests on the proposed mapping approach in two scenarios that included multiple GNSS-rejected areas. Even when several hundred metres of GNSS signal-obstructed areas were present in the scene, the relocation results indicated that the three-dimensional position error obtained using point-cloud maps was <0.15 m and the pitch/roll error was better than 2°. Compared with Fastlio2 and Fastlio2-SC (Fastlio2 with Scan Context), the proposed method had a better mapping effect and higher mapping accuracy in the aforementioned scenarios. The method proposed in this paper can reduce the human cost in traditional modeling and can provide more rapid and accurate map for related industry applications. The method proposed in this paper can reduce the human cost in traditional modeling and can provide more rapid and accurate map for related industry applications.