Efficiency droop in AlGaN crystal-based UVB LEDs in the context of electron blocking mechanism

Abstract

Aluminum gallium nitride (AlGaN) based UVB LEDs are delivering an increase in efficiency under low current drive, however, the devices are confronted with high efficiency droop and high operating voltages during the measurement on bare-wafer under high current drive. Such issues in UVB LEDs are attributed to using conventional p-type multi-quantum-barrier electron-blocking layer (p-MQB EBL) and fixed Al-contents in the p-AlGaN hole-source layer (HSL). When the conventional p-MQB EBL and bulk p-AlGaN HSL was replaced by Al-graded ud-AlGaN EBL and Al-graded p-AlGaN HSL, respectively, the efficiency droop has been remarkably suppressed and almost uniform external-quantum efficiency (EQE) under high injection current was confirmed. Also, the operating voltages under 150 mA drive were significantly reduced from 64 V (conventional p-MQB EBL) to 24 V (new polarized ud-AlGaN EBL) in UVB LEDs. These improvements are attributed to the smooth valance band edge without any potential barrier in both Al-graded ud-AlGaN EBL and Al-graded p-AlGaN HSL for efficient injection efficiency. At the same time the new structure was considered useful for both blocking of high energy electron overshooting toward the p-side as well as Mg-diffusion toward the multi-quantum wells (MQWs) under high current drive. These experimental results were also confirmed by simulations.