Effects of weathering on single-domain magnetite in Early Pliocene marine marls

Abstract

Rock magnetic parameters are often used to recognize variations in the original magnetic mineralogy and for normalizing purposes in palaeointensity studies. Incipient weathering, however, is shown to have a profound but partly reversible influence on the rock magnetic properties of the marls of the Early Pliocene Trubi formation in southern Sicily (Italy). The remanence in the marls resides in single-domain (SD) magnetite grains, but the remanent coercive force (Hcr) shows a strong variation and most values observed are anomalously high (Hcr) range 36–188 mT). The enhanced coercivities are attributed to stress in the magnetite grains induced by surface oxidation at low temperature. Upon heating to 150 °C a reduction of coercivities occurs that can be explained by a stress reduction as a result of a reduction of Fe2- gradient due to a higher diffusion rate at elevated temperature. After heating to 150 °C, coercivities are quite uniform throughout the outcrop and the values are characteristic of SD magnetite (Hcr range 30–38 mT). The bulk susceptibility increases by 4–24 per cent, and the isothermal remanent magnetization (IRM) decreases by 5–11 per cent. The increase in anhysteretic remanent magnetization (ARM) is large: 20–242 per cent. The magnitude of the changes is related to the degree of weathering. Another effect of heating the marl samples to 150 °C is a substantial reduction of the coercivities of the secondary overprint in the natural remanent magnetization. After heating. separation of the secondary and primary components by alternating-field demagnetization is more efficient. The usual difficulties of thermal demagnetization above 300 °C may thus be avoided by a combination of moderate heating to 150 °C and subsequent alternating-field demagnetization.