Effects of the polymerization and pervaporation operating conditions on the dehydration performance of interfacially polymerized thin‐film composite membranes

Abstract

AbstractThe disadvantage of dense polyamide membranes when applied in the pervaporation separation process is their low permeation rates. To improve the pervaporation performance, polyamide thin‐film composite membranes were prepared via the interfacial polymerization reaction between ethylenediamine (EDA) and trimesoyl chloride (TMC) on the surface of modified polyacrylonitrile (mPAN) membranes. These composite membranes were applied in the pervaporation separation of alcohol aqueous solutions. On the basis of the best pervaporation performance, the desired polymerization conditions for preparing the polyamide thin‐film composite membranes (EDA–TMC/mPAN) were as follows: (1) the respective concentration and contact time of the EDA aqueous solution were 5 wt % and 30 min and (2) the respective concentration of and immersion time in the TMC organic solution were 1 wt % and 3 min. The polyamide thin‐film composite membranes (EDA–TMC/mPAN) exhibited membrane durability when applied in the pervaporation separation of a 90 wt % isopropyl alcohol aqueous solution at 70°C, which indicated that the polyamide thin film composite (TFC) membranes were suitable for the pervaporation separation process at a high operating temperature. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2009