Abstract

Advanced civil aero-engines tend to adopt lean burn combustors to meet emission requirements. The exit of a lean burn combustor experiences highly non-uniformities in both temperature (Hot Streak, HS) and flow (swirl). This paper presents a numerical investigation on the behaviors of a High-Pressure (HP) turbine under a combined effect of swirl and hot streak. The investigation was conducted on a GE-E3 HP turbine with unsteady numerical simulations, which considered the realistic clocking position of the HP Nozzle Guide Vane (NGV) relative to the combustor. The influences of swirl orientations on the HS migration and thermal performances on the blade surface were examined. Results indicate that, inside the NGV passage, the swirl’s induced incidence angle effect dominates the HS radial migration. The transversal movement of HS follows the cross flow and thus makes itself approach the Suction Side (SS) and keep away from the Pressure Side (PS) as passing through the NGV, so that HS near the SS is more influenced by the incidence angle effect than that near the PS. As for the heat transfer, swirl affects the Heat Transfer Coefficient (HTC) on the NGV’s PS and SS mainly through the incidence angle effect. Different from the NGV, the inlet swirl and HS have limited effect on the HTC on the rotor blade’s PS, while on the rotor blade’s SS, the original vortex system dominates; therefore, the inlet non-uniformities merely enhance the HTC on the SS rather than alter its distribution characteristics.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call