Effects of Strain Amplitude and Loading Path on Cyclic Behavior and Martensitic Transformation of 304 Stainless Steel

Abstract

Effects of strain amplitude and loading path on cyclic deformation behavior and martensitic transformation of 304 stainless steel were experimentally investigated at room temperature. Series of symmetrical strain-control low cycle fatigue tests with strain amplitude ranging from 0.4% to 1.0% and various loading paths (uniaxial, torsional, proportional, rhombus, square and circular) with the same equivalent strain amplitude of 0.5% were carried out. Three-stage cyclic deformation behavior containing initial hardening, cyclic softening or saturation, and secondary hardening as well as near-linear relationship between α’-martensite content and number of cycles was observed during the whole life regime as for each test. Besides, a nearly linear relation between peak stress and α’-martensite content was found during secondary hardening stage. Furthermore, higher strain amplitude or non-proportionality of loading path resulted in higher cyclic stress response and α’-martensite content growth rate, defined by the slope of curves of α’-martensite content versus number of cycles.