Effects of short fiber tip geometry and inhomogeneous interphase on the stress distribution of rubber matrix sealing composites

Abstract

ABSTRACTThe normal and interfacial shear stress distributions with flat fiber tip of short‐fiber‐reinforced rubber matrix sealing composites (SFRC) compared with the shear lag model were investigated by using the finite element method (FEM). The results indicate that stress values do not agree with those calculated by the shear lag model. The effect of different geometrical shapes of fiber tip on the stress distributions of SFRC was also investigated. The geometrical shapes of fiber tip under present investigation are flat, semi‐elliptical, hemispherical, and circular cone, respectively. The results show that the hemispherical fiber tip transfers the load with less stress concentration and is contributed to controlling the interface debonding failure more effectively than other shapes of fiber tip. Further study on the effect of the inhomogeneous interphase properties on the normal and interfacial shear stresses of hemispherical fiber tip was also conducted. The results indicate that the normal stress increases with the increase of the interphase thickness and interfacial shear stress remains unchanged, and the normal stress values of SFRC with interphase are higher than those without interphase. The interphase elastic modulus has no influence on the stress distributions along the direction to the fiber axis. The stress distributions along the radial direction in the interphase end are largely dependent on the interphase elastic modulus, and the interfacial shear stress is larger than the normal stress, which reveals that a significant part of the external load is transferred from the fiber to the matrix through shear stresses within the interphase. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015, 132, 41638.