Abstract
Four kinds of rail steels were tested to investigate the wear behaviors of wheel–rail materials under three kinds of axle loads. Results indicate that the increase in axle load not only significantly enlarges the wear loss but also enlarges the depth and the length of the fatigue cracks. However, with the decreases in the hardness ratios, some ripples are exhibited on the surface, and the wear surfaces become much rougher; the subsurface analyses deliver the presence of extremely rough surface, and the deformation depths are irregular. The relationship between the total wear loss of the wheel/rail system and the hardness ratio indicates that the hardness ratio of wheel/rail steels has slight impact on the total wear loss at a low axle load; however, the decrease in the hardness ratio enlarges the total wear loss significantly at a high axle load. In summary, a quenched rail should be chosen for the heavy-haul railway, and the hardness of the wheel steel should be raised to a degree close to the rail. However, a hot rolled rail is much suitable for the high-speed railway, and the wheel hardness should be smaller than the rail.
Highlights
Wheel/rail interface plays a fundamental role in determining the reliability of railway transportation, especially for the heavy-haul and high-speed railways
When the wheel/ rail system of hot rolled U71Mn rail steel is under a low axle load (16 T), the delaminated flakes are rather fine, and many delaminated layers can be observed on the wear scar; the observation of the wear debris shows many large thin flakes, and the flakes are in regular shape
The main conclusions could be summarized as follows: 1. At a low axle load, the delaminated flakes are rather fine, and many delaminated layers can be observed on the wear scar; the observation of the wear debris shows many large thin flakes, and the flakes are in regular shape, which is due to the fatigue cracks that grow in low depth
Summary
Wheel/rail interface plays a fundamental role in determining the reliability of railway transportation, especially for the heavy-haul and high-speed railways. The wear scars of different wheel/rail samples under the axle load of 16 T are shown in Figures 8 and 9.
Sign-in/Register to view highlights & summary 
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call