Abstract
Magnetic force microscope (MFM) is a powerful tool to subtly detect the stray field distribution of magnetic film or particles on a sub-micrometer scale. Due to its huge uniaxial magnetocrystalline anisotropy (Ku~7107 erg cm-3) and high Currie temperature (TC~500℃), FePt alloy in an L10 phase is expected to be coated on the MFM tip to display high coercive force (Hc) and to improve the magnetic stability and MFM resolution. A grain size of~3 nm will be enough to overcome the super paramagnetism. However, the growing fresh FePt films must experience a high temperature annealing (exceeding 700℃) in order to transform their structures thoroughly from a soft A1 phase into the desired hard L10 phase. This brings the risk of diffusion between FePt coating layer and the underneath Si cantilever. Several admixtures have been attempted by other researchers to obtain granular films with FePt grains separated by oxides, with the purpose to prevent the diffusion from happening between FePt and Si. But apparently, it will be very difficult to fabricate a separated FePt grain exactly on the top of MFM tip. This is a critical factor to affect the MFM resolution. And discussion about the influence of the interface diffusion is avoided in most of published papers. Alternatively, some oxide isolation layers with higher melting temperature can be useful for separating the top FePt film from the bottom Si crystal. In this paper, MgO and SiO2 are selected as isolation layers, deposited by magnetron sputtering. Subsequently, the FePt films are deposited at 400℃ and annealed at different temperatures (500℃ to 800℃) for 2 h. The experimental results indicate that the diffusion between FePt and Si substrate always occurs in the absence of any isolation layer, leading to a reluctant maximum Hc of~5 kOe for 50 nm FePt film. However, the coercive force could remarkably exceed 10 kOe if an isolation layer is used. In the case of MgO, a maximum Hc of~12.4 kOe for 50 nm FePt could be stably measured. However, the annealing temperature must be lower than 600℃ to hold back the occurrence of brittle cracks in isolation layer. Because of the smaller lattice mismatch and expansion coefficient difference between SiO2 isolation layer and Si substrate, the highest annealing temperature could exceed 800℃ when replacing MgO with SiO2. The Hc of FePt film could be adjusted in a range from~5 kOe to~15 kOe by changing the annealing temperature. These findings greatly benefit the fabrication of FePt-based MFM tips with high Hc. And it is expected to be able to effectively enhance the resolution of MFM image.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.