Abstract
The selection of manufacturing conditions is very important in manufacturing processes as these ones determine the material removal rate (MRR) of the so-obtained parts. So in this paper, based on the brief introduction of the experimental principle and the high-speed small hole EDM drilling system, effects of non-electrical parameters on MRR are discussed in detail. The relationships between MRR and these factors are also analyzed. The conclusion can provide an important reference for production in practice.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.