Abstract
The mechanism that the magnetic field and the dispersant are helpful to chip removal, to improve the material removal rate (MRR) and to reduce the tool wear rate (TWR) was analyzed in detail.The corresponding experiments were conducted based on theoretical analysis. The experimental results show that adding a certain proportion of dispersant into the dielectric fluid and introducing the magnetic field for high speed small hole drilling by EDM can greatly improve the material removal rate and significantly decrease the tool wear rate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
