Effects of methyl methacrylate grafting and polyamide coating on the interfacial behavior and mechanical properties of jute‐fiber‐reinforced polypropylene composites

Abstract

AbstractIn recent years, environmentally friendly materials have become popular because of the growing environmental demands in human society. Natural fibers are now widely used as reinforcements in polymer matrix composites for their various advantages such as low cost, light weight, abundant resources, and biodegradability. However, the applications of these kinds of composites are limited because of their unsatisfactory mechanical properties, which are caused by the poor interfacial compatibility between the fibers and the thermoplastic matrix. In this paper, three methods, including (i) alkali treatment, (ii) alkali and methyl methacrylate (MMA) treatment, and (iii) alkali and polyamide (PA) treatment (APT), were used to treat jute fibers and improve the interfacial adhesion of jute‐fiber‐reinforced polypropylene (PP) composites (JPCs). The mechanical properties of the JPCs were tested, and their impact fracture surfaces were observed. Infrared spectral analysis showed that MMA was grafted and that PA was coated onto the surface of jute fibers. Mechanical tests indicated that the three kinds of pretreated composites presented better mechanical properties than untreated composites. Among them, the APT composite had the best comprehensive properties. Compared with untreated composites, the tensile strength, flexural strength, and flexural modulus of APT composite were increased by 24.8, 31.3, and 28.4%, respectively. Analysis by scanning electron microscopy showed that better interfacial compatibility between jute fibers and PP occured in this kind of composite. J. VINYL ADDIT. TECHNOL., 2012. © 2012 Society of Plastics Engineers