Effects of heat treatment on the microstructure and corrosion behavior of manganese aluminum bronzes

Abstract

Abstract Due to a much lower nickel content, manganese aluminum bronzes (MAB) are a cost-effective alternative to nickel aluminum bronzes (NAB). When the material is processed, different microstructures are observable in the material which have an impact on the corrosion resistance of MAB alloys. MAB samples were annealed at 900 °C and quenched in water. After that, annealing treatments at 600, 500, 400 and 300 °C for up to 24 h were performed and the samples were again quenched in water. Metallographic sections were prepared from all samples and potentiostatic corrosion tests at different potentials were performed in synthetic seawater. It was found that the sample annealed at 900 °C and quenched in water as well as those samples which underwent a second annealing treatment at low temperatures for shorter times exhibited a greater corrosion tendency than those undergoing a second annealing treatment at higher temperatures. X-ray diffraction measurements revealed that phase transformations and changes in grain size occurred during the annealing treatments. The increase in corrosion resistance as a result of annealing at higher temperatures is probably due to the strong intergrowth of the phases that are formed.