Abstract
In this study, drop-weight tear tests (DWTT) were conducted on API X80 pipeline steels fabricated with different finish rolling temperatures in order to analyze abnormal fracture appearance, i.e., inverse fracture, occurring in the region impacted by a hammer. Area fractions of fracture modes were measured from fractured DWTT specimens, and the measured data were analyzed in relation to microstructures, DWTT absorbed energy, and strain hardening of the hammer-impacted region. As the finish rolling temperature decreased, the volume fraction of fine-grained acicular ferrite increased, while that of large-grained upper bainite or granular bainite decreased. According to the DWTT results, the absorbed energy tended to increase with increasing volume fraction of acicular ferrite (with decreasing finish rolling temperature). A large area of inverse fracture of cleavage type was found in the hammer-impacted region of the steels fabricated with high finish rolling temperatures, but the area fraction of inverse fracture was reduced in the steels fabricated with low finish rolling temperatures. Since the area fraction of inverse fracture was closely related with strain hardening of the hammer-impacted region, it could be successfully reduced by lowering strain hardening and by promoting the formation of acicular ferrite via low finish rolling temperatures.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.