Abstract
The effects of steam and gamma sterilization on the performance of bulk-micromachined pressure sensors were investigated using a variable pressure setup. Commercially available piezoresistive MEMS (microelectromechanical systems) pressure sensor die were characterized prior and subsequent to sterilization over a 0-500 Torr pressure range. The effects of sterilization were examined as changes in sensor output voltage (DeltaV) at various applied pressures. For steam sterilization, DeltaV decreased with applied pressure ranging from +0.27 mV at 100 Torr to -0.14 mV at 500 Torr. In contrast, the corresponding values for gamma-sterilized sensors were lower, decreasing from +0.01 mV 100 Torr to -0.06 mV at 500 Torr. The increased variation in DeltaV for the steam-sterilized sensors was attributed to the formation of an oxide film, which was confirmed using energy dispersive X-ray (EDX) spectroscopy. Statistical analysis revealed that the effect of both sterilization procedures on sensor performance was insignificant.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
