Effects of an Electrode Material on a Novel Compound Machining of Inconel718

Abstract

Compound machining (CM) compounded by arc machining and electrical discharge machining (EDM) milling is a new and fast processing method used to machine so-called “difficult-to-machine” materials. This method has an exciting maximum material removal rate that reaches 11,218 mm3/min with the relative electrode wear rate (REWR) of 1.54% when machining Inconel718. The electrode material is an important factor that affects the processing cost and quality of CM. Traditionally used electrode materials in arc machining and EDM, including pure tungsten (W), cerium tungsten (WCe20), copper (Cu), tungsten copper alloy (W80), and graphite (C), were used as electrode materials to process Inconel718. Experimental results show that tubular C is the best electrode material for CM. When tubular C is unavailable, WCe20 is the suitable electrode material for rough machining and W is a better choice in finish machining. Cu electrode is unsuitable for CM because of its low melting point. Results of this work provide guidance for selecting electrode materials for the industry application of efficient CM.