Abstract
The effects of Al–Mg wire replacing Al–Cu wire on the microstructure, microhardness and tensile properties of 2219 aluminum alloy tungsten inert gas (TIG)-welded joints were studied. Comparing joints with Al–Cu wire, the capping welds of joints with Al–Mg wire can be strengthened by the introduction of Mg-containing strengthening phase and the hardness can be significantly improved. However, for joints with Al–Mg wire, both the solidification cracks caused by inappropriate control of alloying element content and the continuous brittle phases at grain boundaries around the weld zone (WZ) can result in the reduced tensile properties. The crack-free weld can be obtained by adjusting the alloying system of WZ. Furthermore, the geometry of WZ also affected the tensile properties of joints with Al–Mg wire.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
