Abstract

Abstract A comparative evaluation of the influence of welding current on Tungsten Inert Gas (TIG) welding and Activated Tungsten Inert Gas (ATIG) welding on the depth of penetration and microstructure properties was performed. Various super duplex stainless steel (SDSS) beads on plate weld joints were studied. Visual observation showed that lower welding current resulted in partial weld penetration in the case of both TIG and ATIG weldments. Weld joints obtained by the ATIG process have a higher depth of penetration and depth/width ratios than weld joints obtained in the conventional TIG process at comparatively lower welding currents. Further, microstructural characterizations were performed using optical microscopy. The weld zone microstructure consists of grain boundary austenite (GBA), widmanstätten austenite (WA) and intragranular austenite (IGA). Ferrite percentage in bulk material and each weldment was measured using ferrite scope. The TIG-welded heat affected zone (HAZ) joints showed higher ferrite content than activated flux TIG-welded HAZ joints for various welding current conditions. Ferrite content measured in the weld-zone, HAZ and base material was within the ranges of the standard values. The TIG weld zone showed higher hardness than that of the ATIG weld zone.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call