Abstract
The effect of the water pressure, traverse speed, and abrasive feed rate on the circularity, cylindricity, kerf taper, and surface roughness of holes produced by abrasive waterjet machining (AWJM) of a carbon-fibre-reinforced polymer (CFRP) composite was investigated in the current study. It was found that the circularity deviation decreased as the water pressure was increased. Cylindricity was affected by all three parameters, although the abrasive feed rate caused the largest deviations as it increased. The surface roughness was affected by all three, but a clear connection was not able to be concluded. The kerf taper ratio reduced with an increase in water pressure, while it increased with an increase in the abrasive feed rate and an increase in the traverse speed. To obtain optimum results, the water pressure should be increased, the traverse speed should be decreased, and the abrasive feed rate can remain constant but is recommended to be slightly reduced.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
