Abstract
Sintered NdFeB magnet is widely used in many areas because of its excellent magnet. This paper studies the effect of ultrasonic vibration of tool on electrical discharge machining of it. Experiments were carried out on self-made equipment and material removal rate(MRR) against pulse-on time, MRR versus peak current and machined surface results with and without ultrasonic employment were analyzed. Results show that MRR of the ultrasonic assisted electro-discharge machining would be up to five times higher than MRR of the conventional EDM for small pulse durations and low discharge currents. The machined surface of US/EDM is finer than EDM because of less arcing and short circuit pulses. There are less cracks on the surface.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
