Effect of TiC nanoparticles on microstructural and tribological properties of Cu-TiC nano-composites

Abstract

The present study has investigated the role of the addition of TiC nanoparticles on the microstructural, mechanical, physical, and metallurgical properties of the Cu-TiC nanocomposites. A Powder metallurgy route was used to fabricate the samples. Cold compaction of powders was done at 480 MPa which was followed by sintering at 950°C. Wt.% of TiC was varied from 0% to 20%. A Pin-On-Disc tribometer was used to carry out the wear and friction tests. SEM and EDS techniques were used to explicate the morphology and microstructures of worn surfaces and to comprehend the underlying wear mechanism. The fabricated samples were investigated against the applied normal load (10, 20, and 30 N), sliding speed (0.5, 1.0, and 1.5 m/s), and sliding distance (900, 1800, and 2700 m). The results revealed that the Hardness and tensile strength were improved by 88.76% and 37.26% respectively due to the addition of TiC and were maximum for Cu-20%TiC while the relative density shows the reverse trend. Further, it was found that wear resistance and coefficient of friction were improved by 87.18% and 51.85% respectively as a function of nano-TiC content. The presence of oxide layers and mechanically mixed layers are detected from worn surface analysis which modulates the tribological behavior of the contact.