Effect of the Vortex on the Movement Law of Sand Particles in the Hump Region of Pump-Turbine

Abstract

The pump turbine, as the core equipment of a pumped storage power plant, is most likely to operate in the hump zone between condition changes, which has a great impact on the stable operation of the power plant, and the high sedimentation of a natural river will lead to wear and tear in the overflow components of the equipment. Therefore, this paper is based on the Euler–Lagrange model, and seeks to investigate the distribution of vortices in the hump zone of the pump turbine and its effect on the movement of sand particles. The study shows that as the flow rate increases, the strip vortex in the straight cone section of the draft tube becomes elongated, and the cluster vortex in the elbow tube section gradually decreases. The strip vortex encourages the sand particles to move along its surface, while the cluster vortex hinders the movement of the sand particles. The accumulation areas of the sand particles in the straight cone section and the elbow tube section increase axially and laterally, respectively. The blade vortex in the runner gradually occupies the flow channel as the flow rate increases, and the blade vortex near the pressure surface encourages the sand particles to move towards the suction surface, resulting in the serious accumulation of sand particles on the suction surface. As the flow rate increases, the number of blades where sand particles accumulate increases and the accumulation area moves towards the cover plate and the outlet. The flow separation vortex in the double-row cascade decreases as the flow rate increases, which drives the sand movement in the middle and lower sections of the vanes. The area of sand accumulation in the stay vane decreases with increasing flow rate, but the area of sand accumulation between the guide vanes increases and then decreases. The vortex on the wall surface of the volute gradually decreases with the flow rate, and the vortex zone at the outlet first decreases, then disappears, and finally reappears. The vortex at the wall surface suppresses the sand movement, and its sand accumulation area changes from elongated to lumpy and finally to elongated due to the increase in flow. The results of the study provide an important theoretical reference for reducing the wear of pump turbine overflow components.