Abstract
Polyvinyl chloride (PVC)/Aliquat-336 microspheres were prepared with the phase inversion method and optimized for red Cibacron dye adsorption. Response surface methodology (RSM) was used to maximize the adsorption capacity. The optimized parameters were the PVC fraction in the dimethylformamide (DMF) solvent, the Aliquat-336/polymer ratio, and the volume fraction of ethanol in the water coagulation bath. The model significant parameters found were the Aliquat-336/polymer ratio and the ethanol volume fraction. The maximum adsorption of 73.7425 mg g−1 was obtained by optimization with an Aliquat-336/PVC mass ratio of 1.5 and an ethanol volume fraction of 0.0934. This theoretical maximum adsorption capacity was confirmed with the experimental one, which had a close value of about 70.25 mg g−1. Both intraparticle and interparticle diffusion mechanisms controlled the adsorption kinetics, and the equilibrium adsorption time was established as 180 min.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
