Effect of the exposure time on the structure and performance of hydrophobic polydimethylsiloxane–poly(vinylidene fluoride) membranes via a non‐solvent‐induced phase separation process in a clean room

Abstract

ABSTRACTThe objective of this study was to investigate the effects of the exposure time on the properties and permeability of polydimethylsiloxane (PDMS)–poly(vinylidene fluoride) (PVDF) blend hydrophobic microporous membranes, which were fabricated via a non‐solvent‐induced phase separation process at 25 °C and 60% relative humidity in a clean‐room circumstance. For the prepared PDMS–PVDF membranes, the membrane morphologies were observed by scanning electron microscopy. Crystalline structures were observed by X‐ray diffraction. Pore structures were analyzed by membrane porosity and mean pore size. Hydrophobicity was measured by contact angle measurement, and the mechanical properties were characterized by tensile strength testing. Our study results show that with increasing exposure time from 10 to 110 s, all of the membranes showed a similar pore structure: a spongelike substrate layer with a thin realm of fingerlike structures under the top surface. Phase separation between PDMS and PVDF occurred. The membrane porosity and mean pore radius decreased, and the membrane thickness increased. The membrane hydrophobicity decreased, and the mechanical properties first increased and then decreased. In addition, vacuum membrane distillation experiments were conducted. With the increase in the exposure time from 10 to 110 s, the membrane permeate flux decreased from 16.54 to 6.65 kg m−2·h−1, and the salt rejection was higher than 99.9%. © 2016 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2016, 133, 43842.