Abstract
The dependence of microstructures and mechanical properties on tempering temperature (from 180 to 650°C) in a designed 3Mn-Si-Ni martensitic steel was systematically analyzed. Microstructure was characterized using scanning and transmission electron microscopy; mechanical properties were measured using uniaxial tensile test and Charpy V-notch impact test. After tempering at different temperatures, recovery, partial recrystallization, carbides precipitation and decomposition of residual austenite were observed. After tempering at 230°C, an excellent combination of strength (1550MPa) and toughness (91.5J) was achieved, due to high dislocation density and ε-carbides precipitation. However, with an increase in tempering temperature from 320 to 550°C, tempered martensite embrittlement was observed, where impact energy was ~ 10J. It was ascribed to cementite formation instead of transition carbides and decomposition of residual austenite. With an increase in tempering temperature up to 650°C, high fracture impact toughness of 75J was obtained with deteriorated tensile strength of 850MPa due to strong recovery and partial recrystallization.
Submitted Version (
Free)
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call