Effect of temperature on the production and diffusion behaviour of furfural in oil–paper insulation systems

Abstract

The existing research on furfural analysis mainly focuses on the relationship between the furfural content in oil and the degree of polymerization (DP) of the paper, which are always obtained by accelerated thermal aging at high temperatures. However, the operating temperature of a winding is relatively low, approximately 60°C to 90°C. Thus, the relationship established at high temperature may be not suitable for the operating temperatures. In this research, aging tests of oil-paper systems at different temperatures ( from 100°C to 130°C) were carried out, with the DP, furfural content in oil and furfural content in paper being measured regularly to analyze the effect of temperature variation on the production and diffusion behavior of furfural in oil–paper insulation. The results show that temperature influences the production of furfural, i.e., there is no obvious difference in the amount of furfural produced by paper in the initial aging periods; however, a higher temperature results in more furfural being produced when the DP decreases to values below 600. An obvious diffusion process occurs after furfural is produced in paper in accelerated aging experiments, resulting in most of the furfural content remaining in the cellulose paper in the initial aging period.