Effect of oil–paper–pressboard mass ratio on furfural content in transformer oil

Abstract

Furfural content in oil is widely accepted as an effective parameter to mirror aging of insulation paper. However, pressboards are also abundant in transformers, which are always neglected in furfural analysis. Different masses of insulation paper and pressboard produce different amounts of furfural during the aging process. Thus, the furfural content in oil may differ in systems with different oil-paper-pressboard mass ratios. To address this problem, accelerated thermal aging experiments and furfural equilibrium experiments with different oil-paper-pressboard mass ratio systems were conducted under laboratory conditions. Furfural contents in oil, paper, and pressboard were measured. In a simplified oil-paper system, the furfural content in oil differs in systems with different oil-paper mass ratios. Further analysis shows the furfural amount produced by 1 g insulation paper is the same with good repeatability in groups with different mass ratios. Different oil-paper mass ratios change the distribution coefficient of furfural between oil and paper, and an increase in the mass of insulation paper leads to more furfural remaining in the insulation paper. The pressboards in field transformers produce little furfural during the aging process, but absorb part of the furfural from oil, which decreases the furfural content in oil. Therefore, more pressboard in an oil-paper-pressboard system indicates lower furfural content in oil. An increase in insulation paper in the oil-paper-pressboard system causes a decrease in the effect of pressboard on furfural content in oil.