Effect of stacking position on drying rate during radio-frequency vacuum combined with mechanical press drying of Douglas-fir and Radiata pine

Abstract

In this study, the effect of stacking position in the dryer on the drying rate during radio-frequency vacuum combined with mechanical press (RF/VP) drying was investigated for Douglas-fir and Radiata pine. Drying test was performed at a temperature of 40 °C using RF/VP dryer with approximately 3 m3. The results showed that the stacking position has a significant effect on the drying rate, with a more pronounced decrease in drying rate as the stacking position of specimens approaches the ground plate. Previous moisture content was an important factor in determining the drying rate in both species. The MC distribution of specimens in the dryer before drying was very irregular, but over time, specimens stacked on the RF charge plate side in the dryer tended to have lower MC distributions than those stacked on the ground plate side, which was serious at the specimens in contact with the upper ground plate. In addition, as the MC decreases below the fiber saturation point during RF/VP drying, the difference in MC distribution within the dryer according to the stacking position became clearer. These findings provide new insights into the effect of stacking position on drying rate during the RF/VP drying and are expected to improve RF/VP drying technology.