Effect of SiC content, additives and process parameters on densification and structure–property relations of pressureless sintered ZrB2–SiC composites

Abstract

The effect of SiC content, additives, and process parameters on densification and structure–property relations of pressureless sintered ZrB2–(10–40vol%) SiC particulate composites have been studied. The ZrB2–SiC composite powders mixed by ball-milling with 1.2wt% C (added as phenolic resin) and 3wt% B4C have been uniaxially cold-compacted and sintered in argon environment at 1950–2050°C for 2h, or at 2000°C for durations between 1/2 and 3h. The amount of densification is found to increase with sintering duration, and by prior holding at 1250 and 1600°C for reduction of oxide impurities (ZrO2, B2O3 and SiO2) on powder particle surfaces by the aforementioned additives. Presence of SiC with average size smaller than that of ZrB2 appears to aid in densification by enhancing green density, increasing WC content by erosion of milling media, and inhibiting matrix grain growth. Both SiC and WC appear to aid in reduction of oxide impurities. Furthermore, the impurities enriched in W, Fe and Co obtained from milling media are found to be segregated at ZrB2 grain boundaries, and appear to assist in densification by forming liquid phase, which completely wets the ZrB2 grains. Hardness increases with SiC content or with sintering duration till 1h, but decreases for periods ≥2h due to grain growth. The experimentally measured elastic moduli approaches corresponding theoretically predicted values with increasing SiC content due to reduction in porosity.