Effect of self-developed graphene lubricant on tribological behaviour of silicon carbide/silicon nitride interface

Abstract

The research presented in this paper aims to investigate the effectiveness of different surface roughness and lubrication conditions on the interfacial tribological properties between silicon carbide (SiC) and silicon nitride (Si3N4) ceramics, particularly for providing insight into the mechanisms of how graphene reduces the friction and wear rate. The worn groove topography and surface composition were characterised in detail with 3D laser measuring microscopy and X-ray photoelectron spectroscopy. The tribological test results on the UMT-TriboLab show that a smooth initial surface is more likely to obtain a low friction coefficient and wear rate under water lubrication. The proper initial surface roughness for SiC and Si3N4 ceramics is approximately Ra 10 nm, and it will be lower in an alcohol or graphene aqueous solution. A large load does not worsen the tribological behaviour of a Si3N4 ball sliding against a SiC disk, and it reduces the friction coefficient and wear rate. Among the five lubrication states of dry friction, dry graphene lubrication, water lubrication, graphene solution lubrication, and self-developed graphene lubrication, the self-developed graphene lubricant can exhibit an ultra-low friction coefficient of 0.009 and ultra-low wear rate of 1.69 × 10−7 mm3/N·m. The excellent tribological property of the graphene-coated ceramic surface helps the prepared lubricant to decrease the friction coefficient effectively. Furthermore, the graphene film can protect the SiC from being oxidised by water under the tribo-activated action, and therefore, lead to ultra-low wear rate under low friction condition. Alcohol improves the tribological property of the self-developed graphene lubricant, mainly because of the good wettability between graphene and ethanol. The self-developed graphene lubricant can be applied in water-lubricated ceramic bearings and motorised precision spindles.