Effect of repair patch nature on J-integral reduction in notched plates

Abstract

PurposeThe purpose of this research is to evaluate the effectiveness of different repair patch materials in reducing the stresses at the crack tip of a 2024-T3 aluminum plate. This involves a numerical analysis using the finite element method (FEM) to estimate the reduction in the J-integral value, with the goal of identifying how various parameters related to the patch materials, adhesive properties and loading conditions influence the structural integrity of the repaired plate.Design/methodology/approachThe methodology of this research involves conducting a numerical analysis using the FEM to estimate the reduction in the J-integral value at the crack tip of a 2024-T3 aluminum plate. Three types of patches – metal, composite and functionally graded material (FGM) – were examined under tensile loading conditions, and Adekit-A140 adhesive was used to bond these repair patches to the aluminum plate.FindingsThe analysis considered various parameters, including crack length, the nature of fibers in the composite material, the gradation exponent for FGM patches and the nature of the face in contact with the adhesive for the FGM patch. Additionally, stress analysis was conducted, examining the J-integral values for the plate, shear stress in the adhesive layer and peel stress in the composite patch. The findings highlight that modifying the nature of the repair patch used can significantly enhance the structural integrity of the repaired plate.Originality/valueThe study analyzed J-integral values, shear stress in the adhesive and peel stress in the composite patch. Various parameters, including crack length, fiber type, gradation exponent and adhesive contact face nature, were considered. Results demonstrate that the J-integral value can be significantly reduced by altering the repair patch type, highlighting the effectiveness of customized patch materials in enhancing structural integrity.