Abstract

Pulsation of current is widely employed in Tungsten Inert Gas (TIG) welding of titanium alloys. In the current study, the influence of welding speed and welding currents (peak and background) on the properties pulsed TIG welded Ti-5Al-2.5Sn alloy were investigated. The weldment characteristics which were analyzed included weld zone size, microstructure, residual stresses, tensile and impact properties. Increasing the welding speed and gradient of pulsed current enhanced grain strengthening in the fusion zone (FZ) which was attributed to increased cooling rate. Such a welding condition was also favorable in achieving full penetration weldments with a reduced; heat affected zone width, grain size in FZ and residual stresses. However, a tensile strength superior to the base metal was observed. The impact toughness reduced by increasing the pulsed current gradient and a high value of both peak and background currents were required to improve the impact toughness of the weldments.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.