Effect of Pre-Rolling on Microstructure and Fatigue Crack Propagation Resistance of a Third-Generation Al-Li Alloy.

Abstract

The effect of pre-rolling on the microstructure and fatigue crack (FC) propagation resistance of the Al-Cu-Li alloy was studied using tensile testing, fatigue testing, transmission electron microscopy (TEM), X-ray diffractometer (XRD), and scanning electron microscopy (SEM). The results revealed that reducing the alloy thickness through pre-rolling by up to 12% enhanced both tensile strength and yield strength, albeit at the expense of reduced elongation. In addition, the FC growth rate decreased by up to 9% pre-rolling, reaching the minimum, while the application of additional mechanical stress during the pre-rolling increases this parameter. Deformations in the Al-Cu-Li alloy with less than a 9% thickness reduction were confined to the surface layer and did not extend to the central layer. This non-uniform deformation induced a compressive stress gradient in the thickness direction and led to an inhomogeneous distribution of T1 phase, resembling the structure generated by shot peening. The superior FC propagation resistance in the 9% pre-rolled alloy could be primarily attributed to the optimum balance of compressive residual stress and work hardening.