Abstract
The objective of this study was to compare potassium hydrogen difluoride (KHF2) etching for zirconia with commonly used surface roughening and chemical bonding methods (silane, MDP-monomer primer) for resin-based luting cement bonding to zirconia. Zirconia specimens were divided into six groups (n=10) according to surface treatment and bonding procedures, with and without thermocycling (6,000 cycles, 5-55ºC): 1) air-borne particle abrasion with alumina+MDP-monomer (ABP), 2) air-borne particle abrasion with silica-coated trialuminium trioxide+silane (ABPR-S) and 3) KHF2 etching+silane (ETC). Surface roughness and bond strength (SBS-test) for dry and thermocycled specimens were measured. SBS did not vary statistically between the dry groups, but thermocycling decreased the bond strengths of all the tested methods (p<0.05). After thermocycling, ABP had statistically significantly lower bond strength values compared to ABPR-S and ETC (p<0.05). Etching method with KHF2 did not provide better bonding capacity to previously introduced and commonly adopted bonding methods.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
