Effect of Mg Addition on the Microstructure and Properties of a Heat-Affected Zone in Submerged Arc Welding of an Al-Killed Low Carbon Steel.

Yandong Li,Xiaobing Li,Kui Liu,Yingche Ma,Yi Min,Weiwei Xing,Bo Chen

doi:10.3390/ma14092445

Abstract

To reveal the effect of Mg treatment on the microstructure evolution behavior in the actual steel welding process, the microstructure and properties of Al-deoxidized high-strength ship plate steel with Mg addition were analyzed after double-side submerged arc welding. It was found that the Al–Mg–O + MnS inclusion formed under 26 ppm Mg treatment could promote acicular ferrite (AF) nucleation in the coarse-grained heat-affected zone (CGHAZ) and inhibit the formation of widmanstätten ferrite and coarse grain boundary ferrite. In the fine-grained heat-affected zone (FGHAZ) and intercritical heat-affected zone (ICHAZ), polygonal ferrite and pearlite were dominant. Al–Mg–O+MnS cannot play a role in inducing AF, but the grain size of ferrite was refined by Mg addition. The impact toughness in HAZ of the Mg-added steel was higher than that of Mg-free steel. With the heat-input rising from 29.55 to 44.11 kJ/cm, it remained relatively stable in Mg-treated steel. From the fusion line to the base metal, the micro-hardness of the fusion zone, CGHAZ, ICHAZ and FGHAZ decreased to some extent after Mg addition, which means the cold cracking tendency in the welding weak zone could be reduced. Finally, the mechanisms of Mg-containing inclusion-induced AF were also systematically discussed.

Highlights

High-strength ship plate steel is widely used in military ships, special vessels, large ships, and other major national defense and civil-use fields
intercritical heat-affected zone (ICHAZ), the dominated microstructure is polygonal ferrites (PF) mixed with a small amount of pearlite
The micro-hardness test results indicate that with Mg treatment, the hardness of the fusion zone, coarse-grained heat-affected zone (CGHAZ), and fine-grained or recrystallization heat-affected zone (FGHAZ) are all decreased to some extent

Summary

Introduction

High-strength ship plate steel is widely used in military ships, special vessels, large ships, and other major national defense and civil-use fields. Oxide metallurgy is an effective method proposed in recent years to improve the performance of the steel welding heat-affected zone [3,4]. This method induces a large amount of small and dispersed oxide particles formed in steel through an appropriate deoxidization process. During the post-weld cooling process, these oxide particles can be used as ferrite nucleation sites to promote the formation of interlaced refine acicular ferrite (AF) which refines the heat-affected zone microstructure and improves its mechanical performance [3,4].

Methods

Results

Conclusion