Effect of Material and Process Variables on Characteristics of Nitridation-Induced Self-Formed Aluminum Matrix Composites-Part 1: Effect of Reinforcement Volume Fraction, Size, and Processing Temperatures.

Abstract

This paper investigates the effect of the size and volume fraction of SiC, along with that of the processing temperature, upon the nitridation behavior of aluminum powder during the nitridation-induced self-formed aluminum composite (NISFAC) process. In this new composite manufacturing process, aluminum powder and ceramic reinforcement mixtures are heated in nitrogen gas, thus allowing the exothermic nitridation reaction to partially melt the aluminum powder in order to assist the composite densification and improve the wetting between the aluminum and the ceramic. The formation of a sufficient amount of molten aluminum is key to producing sound, pore-free aluminum matrix composites (AMCs); hence, the degree of nitridation is a key factor. It was demonstrated that the degree of nitridation increases with decreasing SiC particle size and increasing SiC volume fraction, thus suggesting that the SiC surface may act as an effective pathway for nitrogen gas diffusion. Furthermore, it was found that effective nitridation occurs only at an optimal processing temperature. When the degree of nitridation is insufficient, molten Al is unable to fill the voids in the powder bed, leading to the formation of low-quality composites with high porosities. However, excessive nitridation is found to rapidly consume the nitrogen gas, leading to a rapid drop in the pressure in the crucible and exposing the remaining aluminum powder in the upper part of the powder bed. The nitridation behavior is not affected by these variables acting independently; therefore, a systematic study is needed in order to examine the concerted effect of these variables so as to determine the optimal conditions to produce AMCs with desirable properties for target applications.