Abstract
Al—(1, 3, 5, 7, 10 vol%) SiC nanocomposites were produced by mechanical alloying (MA) and double pressing/sintering route. The characteristics of the milled powders and the consolidate specimens were examined using high resolution scanning electron microscopy and X-ray diffraction method. Compression and hardness tests were used to study the effect of SiC volume fraction on the strength of Al—SiC nanocomposites. It was shown that with increasing the SiC volume fraction, finer particles with narrower size distribution and smaller crystallite size are obtained after MA. During sintering close to the melting point of aluminum, the presence of nanometer-scaled SiC particles was found to hinder the grain growth significantly. The Al matrix with a higher SiC content exhibited more potential for grain boundary pinning, i.e., smaller grain size was obtained at higher SiC volume fractions. Consequently, an improved mechanical strength was obtained. The processing method (MA/pressing/sintering) can be used for fabrication of near-net shape Al matrix nanocomposites.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
