Abstract

Background. Mechanical models of the human ankle complex are used to study the stabilizing role of ligaments. Identification of ligament function may be improved via image-based personalized approach. The aim of this study is to compare the effect of the ligament origin and insertion site definitions obtained with different magnetic resonance imaging (MRI) modalities on the mechanical behaviour of a dynamic model of the ankle complex. Methods. MRI scans, both via 1.5 T and 3.0 T, were performed on a lower-limb specimen, free from anatomical defects, to obtain morphological information on ligament-to-bone attachment sites. This specimen was used previously to develop the dynamic model. A third ligament attachment site mapping scheme was based on anatomical dissection of the scanned specimen. Following morphological comparison of the ligament attachment sites, their effect on the mechanical behaviour of the ankle complex, expressed by three-dimensional load–displacement properties, was assessed through the model. Results. Large differences were observed in the subtalar ligament attachment sites between those obtained through the two MRI scanning modalities. The 3.0 T MRI mapping was more consistent with dissection than the 1.5 T MRI. Load–displacement curves showed similar mechanical behaviours between the three mappings in the frontal plane, but those obtained from the 3.0 T MRI mapping were closer to those obtained from dissection. Conclusions. The state-of-the-art 3.0 T MRI image analysis resulted in more realistic mapping of ligament fibre origin and insertion site definitions; corresponding load–displacement predictions from a subject-specific model of the ankle complex showed a mechanical behaviour more similar to that using direct ligament attachment observations.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call