Abstract
This study shows that the latent heat of the aluminum alloy in an overlay strip is the key factor affecting the bonding quality of clad strips fabricated by a vertical-type tandem twin-roll caster. Three-layer clad strips, for which the base strip was 3003 aluminum alloy and the overlay strip was Al-1%Si, Al-2%Si, Al-11%Si (4045), Al-2%Mg, and Al-4.5%Mg (5182), respectively, were cast. The 4045 overlay strip bonded to the base strip. However, overlay strips made of the other alloys did not bond to the base strip. The latent heat of Si is much higher than that of Al, which in turn is higher than that of Mg. Therefore, the latent heat of the 4045 alloy was higher than that of the other alloys. The high latent heat of the 4045 alloy allowed it to heat the base strip to a temperature at which bonding was possible.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
