Abstract
A vertical type tandem twin roll caster equipped with a scraper for the clad strip was invented. This roll caster could cast three layers clad strip which base strip had lower melting point than that of the overlay strips. The base strip was cast by an upper twin roll caster and the overlay strips were cast by a lower twin roll caster. The scrapers were attached to the lower twin roll caster, and were innovated to cast this type of three layers of clad strip. Solidification layers those became the overlay strips were pulled from between the scraper and the roll. The melt of the alloy which was as same as the base strip was poured between the scraper and the base strip. This melt connect the overlay strip and the base strip. The base strip was not re-melted. The scraper enabled that the solidification layer of the overlay strip contact to the melt of the base strip without mixing of the melt of the base and overlay strip. In this way, the sound three layers clad strip which base strip had lower melting point than that of the overlay strip could be cast by the vertical type tandem twin roll caster equipped with a scraper.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
