Effect of industrial water components on thermal stability of nitrocellulose

Abstract

Listen

Translate article

In order to prevent the spontaneous ignition of nitrocellulose (NC), NC is stabilized by washing with industrial water in its synthesis process. However, there is a possibility that the components in industrial water contribute to the thermal stability of NC. In this way, the purpose of this study is to clarify the effect of industrial water components on the thermal stability of NC. In experiments, a heat flux calorimeter was used to observe the thermal behavior of NC with the residue of vaporized industrial water. The induction period of heat release of NC with 2-mass% residues was approximately 2-5 h shorter than that of NC alone whose induction period was observed at 7 h. Those results indicate that the residue destabilized NC. On the other hand, when the additive amount of the residue was increased, the induction period gradually increased as well. Based upon these results, we assume that inorganic salts contributing to stabilization and destabilization competitively coexist in the industrial water components. The same thermal analysis was performed on NC with CaCO 3 , CaSO 4 , CaCl, ZnSO 4 , NaCl, and CuCl. Those salts are predicted to exist in the industrial water. In the results, the induction period of NC with 2-mass% CaCO 3 was approximately 15-h longer than that of NC alone, while the induction period with the inorganic salts CaSO 4 , CaCl, ZnSO 4 , NaCl, and CuCl was 4-5-h shorter. Therefore, when the industrial water components accumulate in NC, the destabilization by inorganic salts such as CaSO 4 , CaCl, ZnSO 4 , NaCl, and CuCl and the stabilization by compounds such as CaCO 3 are thought to countervail against each other.