Effect of Heating Process on Flexural Strength and Toughness of CFRTP Molded by Multi-layer Press -Investigation on Effect of Residual Stress-

Abstract

Listen

Translate article

This study investigated the effect of differences in heating process of each mold due to the molding with multi-layer press on changing in mechanical properties of CFRTP. CFRTP specimens molded with 10 pages multi-layer were prepared for 3 point bending tests and DCB tests, ENF tests in order to investigate the different of mechanical properties. The change in the mechanical properties of CFRTP molded by multi-layer press were investigated considering residual stress occurred by differences in heating process of each mold. Average of flexural strength, mode-I interlaminar fracture toughness and mode-II interlaminar fracture toughness of the specimen molded at 5th page were decreased compared with that of 1st page. Assuming the fiber as a rigid and considering the thermal shrinkage of resin, compressive residual stress should be occurred in the fiber since free shrinkage of the resin was constrained. It was considered that the reduction of flexural strength with the failure close to the compression surface was caused due to this additional compressive residual stress. The tensile residual stress also should be occurred in the resin due to constraint of free shrinkage of the resin. The observed reduction of toughness in the resin was also occurred for the procedure of crack propagation. The reduction rate of mode-I interlaminar fracture toughness was much remarkable than that of mode-II interlaminar fracture toughness. Tensile residual stress in the resin was dominant since the mode-I fracture is a crack opening mode.