Abstract
In this research, a Copper-based composite was fabricated by TiC reinforcement via friction stir processing. Holes with the diameter and depth of 2mm were made on the surface of a pure copper specimen and filled by TiC powders. Friction srir processing was carried out with transverse and rotational speeds of 50mm/min and 1000rpm, respectively. Optical and scanning electron microscope observations revealed that FSP produced a fine grain microstructure with a homogeneous distribution of particles on the surface. Reinforcing particles showed a good bonding with the base metal. Mechanical test results also proved that FSP increased the microhardness and the wear resistance of specimen as a result of grain refinement and the existence of TiC particles in the FSP zone. Maximum hardness in the stir zone was 117 Vickers, while the hardness of pure copper was 65 Vickers. X-Ray analysis proved no intermetallic compounds in the stir zone.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.