Abstract
Purpose The purpose of this study is to conduct research on a new kind of division microchannel heat sink (D-MCHS), which can distribute cooling water along the channel-length direction. First, the pressure drops in the D-MCHS with different division region numbers were compared. Then, the cooling performance of the D-MCHS with different division region numbers was also comparatively investigated. Finally, the temperature distribution on the bottom surface of the D-MCHS was analyzed. Design/methodology/approach First, experiments were conducted to investigate the numerical calculation method. Then, a three-dimensional steady, single-phase, laminar flow and solid-fluid conjugate heat transfer numerical model was used to research the flow and heat transfer characteristics in microchannels. Findings The pressure drop in the D-MCHS could be reduced by increasing the number of divided flow regions along the channel-length direction. The bottom average temperature of the D-MCHS could be simultaneously affected by the number of divided flow regions and the water flow rate. The thermal uniformity performance of the D-MCHS could be improved by increasing the number of division flow regions. The number of low-temperature and high-temperature areas on the bottom surface of the D-MCHS is corresponding to the division flow region number. Originality/value The D-MCHS exhibited a positive effect on the pressure drop decrease and thermal uniformity improvement. It not only keeps the electronic module working in a secure temperature environment but also consumes less pump power for a lower pressure drop.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call