Abstract
The present paper reports experimental investigations on the effect of diffuser vane height and its position on diffuser wall static pressures of a low speed centrifugal compressor. Apart from the standard types of diffusers, namely, vaneless, vane and low solidity vane diffusers, a partial vane diffuser, whose height is less than the diffuser width is also tested. The vane height of the partial vane diffuser is varied from 0.3, 0.4 and 0.5 times the diffuser width in vane and low solidity vane diffuser configurations. In addition, the effect of vane position is examined by fixing the partial vanes to the hub, shroud or hub and shroud. It is found that there is an optimum height for the diffuser vane height, which is found to be 0.3 times the diffuser width. The effect of position of the partial vanes on the hub or shroud on the diffuser wall static pressures is found to be negligible. However when partial vanes are fixed on the hub and shroud staggered at half spacing, the diffuser performance based on wall static pressures is improved substantially.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.