Abstract
In the machining operations, final surface finish and dimensional accuracy are the most specified customer requirements. Hard turning machining operation using cubic boron nitride tool as an alternative of grinding process is a type of turning operation in which hardened steel are machined with the hardness greater than 45 HRc. During the hard turning operation because of the hard condition, the variations of surface finish and dimensional accuracy are completely different from that of the traditional turning operation. Thus, the variation of surface finish and dimensional accuracy under various cutting parameters has been investigated in the hard turning with cubic boron nitride tools. The extracted knolwdge can be used for developing a knowledged base expert system. In order to have a comprehensive study, the variation of vibration, cutting forces, and tool wear has also been considered. The obtained results showed that depth of cut and spindle speed have the greatest effect on the dimensional accuracy, while feed rate is the most important factor affecting the surface roughness. The analysis of the vibration and tool wear proved that the flank wear has insignificant influence on the dimensional accuracy, whereas the vibration effect is considerable. The experimental results showed that when the feed rate is gradually increased from 0.08 to 0.32, the dimensional deviation first decreases unexpectedly until the lowest value is achieved at 0.16 mm/rev, then by further increasing the feed from 0.16 to 0.32 mm/rev, the dimensional deviation increases significantly. It was also seen that the best dimensional accuracy is achieved at the lowest level of the cutting depth, the medium level of the feed rate, and the spindle speed lower than its moderate level. The best surface roughness of 0.312 μm was obtained at 0.08 mm/rev feed rate, 0.5 mm depth of cut, 2000-rpm speed, and 1.2 mm insert nose radius, which is comparable with the surface finish obtained by the grinding operation.
Highlights
When the nose radius is increased from 0.4 to 1.2 mm, the surface roughness improves about 45%
The results reveal that at 0.08 mm/rev feed rate, the surface roughness becomes less sensitive to the changes in the nose radius
In order to perform a comprehensive study on the dimensional accuracy and surface roughness, the variation of vibration, cutting forces, and tool wear under various cutting condition was investigated
Summary
Hard turning with cubic boron nitride (CBN) tools allows manufacturers to simplify their processes and still achieve the desired surface quality and accuracy (Lalwani et al 2008; Yousefi et al 2017; Zohoor and Yousefi 2018; Yousefi and Zohoor 2018; Thiele and Melkote 1999). The criteria like surface roughness, dimensional accuracy, cutting force, wear, and power consumed are usually used for the evaluation of the hard turning performance (Chavoshi and Tajdari 2010; Khrais and Lin 2007; Das et al 2015; Aslan et al 2007; Dhar et al 2006; Dhar et al 2007; Risbood et al 2003; Dhar and Kamruzzaman 2007; Dhar et al 2002; Shahabi and Ratnam 2010; Revel et al 2016; Bartarya and Choudhury 2012).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Mechanical and Materials Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.