Abstract
For the first time, the effect of Cuprous Oxide (Cu2O) sputtering power variation on the radio frequency sputtered Copper Chromium Oxide (CuCrO2) thin films was studied. In this work, the sputtering power of Cr2O3 was held constant at 200 W while the sputtering power of the Cu2O target was varied from 10 to 100 W. The films were subsequently annealed at 650 °C in N2 ambiance. The effects of Cu2O sputtering power variation on the structural, optical, and electrical properties of the films have been reported in this work. X-ray diffractometer (XRD) study revealed that the single-phase delafossite structure of CuCrO2 was only obtained at Cu2O sputtering power of 50 W. X-ray photoelectron spectroscopy (XPS) analysis further established the results of XRD study where Cu in 1+ oxidation state was identified in thin films obtained at 50 W of Cu2O sputtering power. The optical studies were conducted in this work on all the post-deposition annealed films in the wavelength range of 200–800 nm. The energy dispersive x-ray spectroscopy (EDS) study revealed a near stoichiometric composition ratio of 1:1.06 of Cu:Cr at% obtained in the films sputtered with 50 W of Cu2O sputtering power. The highest optical transmission of ~81% and the highest optical bandgap of 3.21 eV were observed for single-phase CuCrO2 thin films. The optical transmission and the optical bandgap were found to decrease with an increase in the Cu2O sputtering power. The electrical study performed on all the post-deposition annealed films revealed that the lowest resistivity of 0.652 Ω-cm was identified for single-phase CuCrO2 thin films obtained at 50 W of Cu2O sputtering power.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call